Altrad PRO 900 Manuel De L'opérateur page 8

Clutch Cable Assembly - Manual Clutch
1. Position the cable through the cable retainer (Check that the outer cable is fully engaged into the cable retainer), then fasten a
cable tie to hold the outer cable in place.Ensure the cable is routed as Diagrams 1 & 2 show.
Now fi t the 75mm long spring onto the cable. (See diagram 3)
1
2. Fit the cable through the hole in the end of the Pivot Arm then screw the 5/16" UNF bolt in to the side of the engine
(See diagram 4). Tighten up the locking nuts on the back of the Pivot Arm, making sure that there is no more than 1mm of
play either side of the centre at the top end where the cable comes through, but so as it still remains to be able to Pivot freely
(See diagram 5).
Fit the M6 x 60mm cap head with a locking nut to the Tensioner Bracket , the cap head should be screwed in a maximum of
5mm. (See diagram 6)
4
3. Fit M5 x 12 Caphead into lever, pull the cable tight and push tensioner arm down with correct distance of 62mm and tighten
grub screw to 6Nm, then place the secondary cable retainer onto the cable so it is sat up to the arm with no slack.
(See diagrams 7 & 8)
7
5.5hp/6hp = 62mm
9hp = 74mm
3a. Once the distance has been set (62mm) apply the Belt. After fi rst 4 Hours or week, whichever comes fi rst, check the Belt
Tension.
Assembly Instructions
2
5
distance from
inside faces
11
6
8
secondary
retainer
GB
3