Publicité
Les langues disponibles
Les langues disponibles
PRE OPERATION
1. BEFORE operating this log splitter, make sure that you wear gear such as goggles or safety glasses, steel
toed shoes and tight fitting gloves (without loose cu s or drawstrings). Always wear a protective hearing
device when operating this log splitter.
2. NEVER wear loose clothing or jewelery that can be caught by moving parts of the log splitter. Keep clothing
and hair away from all moving parts when operating this log splitter.
3. Check all safety guards and shields to be sure they are in the proper position. Never operate with safety
guards, shields or other protective features removed.
4. Make sure machine is on a flat, dry, solid ground before operating.
5. ALWAYS operate your log splitter in an open area. (Exhaust fumes contain carbon monoxide which can
be deadly when inhaled).
6. ALWAYS operate your log splitter in daylight or under good artificial light.
7. ALWAYS operate your log splitter on level ground. (Operating on a slope could cause the log splitter to roll
over or logs fall o ).
8. ALWAYS block wheels to prevent unintended movement.
9. ALWAYS lock beam in either horizontal or vertical position.
10. ALWAYS Keep the work area clean. Remove split wood from around the log splitter immediately so that
you don't stumble over it.
11. Check all nuts, bolts and hydraulic fittings are tight to be sure the equipment is in safe working condition.
12. Both ends of the log should be cut as square as possible to help prevent the log from riding out of the
splitter during operation. Do not split logs greater than 25 inches in length. Uneven logs (e.g. knotted,
curved, etc.) should not be used.
13. ALWAYS check the oil level before you start the log splitter.
14. Do not allow familiarity with tools to make you careless. Remember that a careless fraction of a second is
su cient enough to inflict serious injury.
WARNING
your eyes, which can result in sever eye damage. Before beginning power tool operation,
always wear safety goggles or safety glasses with side shields and when needed, wear a full
faced shield and ear plugs too. We recommend a Wide Vision Safety Mask for use over eyeglasses
or standard safety glasses with side shields. Always use eye protection which is marked to comply
with ANSI Z87.1
The operation of any power tool can result in foreign objects being thrown into
BE-LS25Ex
Publicité
