Publicité
Les langues disponibles
Les langues disponibles
OPERATING INSTRUCTIONS
Using Control Handle
The control handle has three positions. (See Figure 18).
Forward
To split wood. Move the control handle to the FROWARD position to move wedge toward the log to split.
NOTE: The control handle will return to the neutral position as soon as the handle is released during FROWARD
process and the wedge stops moving forward. DO NOT hold the handle at the FORWARD position when the
wedge is fully extended. The over built up pressure may squeeze the pressure relief valve and the control handle
won't be released to NEUTRAL position automatically. Manually pull the handle to NEUTRAL or REVERSE to
recover. Or the hydraulic system may get damaged and void your warranty.
Neutral
To stop wedge. Release the control handle or move the lever to the NEUTRAL position to stop the wedge
movement.
Reverse
To return the wedge. Engage the control handle to the REVERSE position, the wedge will automatically
return toward the cylinder. When the wedge is fully retracted and contacts the handle release lever, the control
handle will return to NEUTRAL position automatically.
NOTE: Do not hold the handle in REVERSE position. It will stay in REVERSE position during the wedge being
retracted. When the wedge is fully retracted, the handle will kick back to the NEUTRAL position automatically.
WARNING!
If the control handle on your log splitter is not functioning properly, STOP USE
IMMEDIATELY and contact an authorized service dealer.
Do not attempt to service, repair or replace control valve. Contact an authorized service dealer.
Do not attempt to adjust or modify the control valve or the hydraulic system from its original
settings or manufacturer in any way.
BE-LS25Ex
(FIGURE 18)
Publicité
