BE Ag & Industrial AGRI EASE BE-LS25E Serie Manuel D'utilisation page 19

ASSEMBLING (CONT.)
Step 6: Connect the hydraulic hoses. See Figure 9.
There are three hydraulic hoses listed below, each of them has one end fixed on the log splitter by manufacturer,
and the other open end still needs to be attached. The hoses are labeled on the ends for easy installation.
1. Oil suction Hose 3/4", Labeled as (1), comes from the bottom of the reservoir. Loosen the hose clamp on the
open end of the hose using a flat head screwdriver, then connect the hose to the fitting on the bottom of the
pump, which is also labeled as (1). Tighten the hose clamp.
2. Pump/Valve connecting hose 1/2", labeled as (2), comes from the bottom of the valve on the beam assembly.
Screw the open end of this hose onto the fitting on top of the pump, which is also labeled as (2).
Tighten using a 27mm wrench or an adjustable wrench.
3. Oil return hose 3/4", labeled as (3), comes from the top of the valve on the beam assembly. Screw the open
end of this hose onto the fitting on the reservoir tank, which is also labeled as (3). Make sure an O-Ring
Ø15*1.9 sitting inside the fitting slot. Or you could find a spare O-Ring in your hardware box. Tighten the hose
using a 32mm wrench or an adjustable wrench.
BE-LS25Ex