BE Ag & Industrial AGRI EASE BE-LS25E Serie Manuel D'utilisation page 25

OPERATING INSTRUCTIONS
Starting & Stopping The Engine
Refer to the Engine Operator's Manual packed with your log splitter for instructions on starting and stopping
the engine.
Beam Operating Positions
1. Place the log splitter on flat, dry, solid ground.
2. Block both wheels to prevent your log splitter from moving during the operation. (See Figure 16).
3. Place the beam in either the horizontal or vertical position and lock into place.
WARNING
Take extra care when raising and lowering the beam as it is fairly heavy. Having a
second person assist with raising or lowering the beam is recommended.
Be sure to keep hands away from any possible pinch points.
Always use the log splitter in the vertical position when splitting heavy logs.
4. To place the beam in the Vertical Position proceeds as follows:
1) Pull the horizontal beam lock lever out and rotate it downward, so it rests against the side of the
lock and remains unlocked. (See Figure 17).
2) Use both your hands to lift up the beam and flip it over the vertical position, then rotate the
horizontal lock lever back up the tongue to release the lock.
5. To place the beam in Horizontal Position:
1) Pivot the beam to the horizontal position.
2) The horizontal beam lock is self-locking. The spring loaded lock will snap into place when the beam
is lowered into position.
(FIGURE16)
(FIGURE 17)
Tongue
BE-LS25Ex
Beam