BE Ag & Industrial AGRI EASE BE-LS25E Serie Manuel D'utilisation page 32

TROUBLE SHOOTING
Most problems are easy to fix. Consult the trouble shooting table below for common problems and their
solutions. If you continue to experience problems, contact your local dealer.
If the machine should start making an unusual noise or vibration, shut down the engine, wait 5 minutes for the
machine to cool down, then inspect for damage. Vibration is generally a warning of trouble. Check for damaged
parts and clean, repair and/or replace as necessary.
PROBLEM
Cylinder rod will not move.
Slow cylinder shaft speed while
extending and retracting.
Leaking cylinder.
Wood will not split or wood splits
too slowly.
Leaking pump shaft seal.
Wedge continues to move forward when
control handle is released.
Control handle does not return to neutral
when released from forward position.
POSSIBLE CAUSE
1. Broken drive shaft.
2. Shipping plugs left in hydraulic hoses.
3. Set screws in coupling not adjusted
properly.
4. Loose shaft coupling.
5. Gear sections damaged.
6. Damaged relief valve.
7. Hydraulic lines blocked.
8. Low oil level or air trapped in
hydraulic system.
9. Damaged control valve.
1. Broken drive shaft.
2. Shipping plugs left in hydraulic hoses.
3. Slow engine speed.
4. Damaged relief valve.
5. Low oil level or air trapped in
hydraulic system.
6. Contaminated oil.
7. Control valve leaking internally.
8. Internally damaged cylinder.
1. Worn seals.
2. Scored cylinder.
1. Small gear section damaged.
2. Pump check valve leaking.
3. Excessive pump inlet vacuum.
4. Low oil level or air trapped in
hydraulic system.
5. Contaminated oil.
6. Control valve leaking internally.
7. Overloaded cylinder.
8. Internally damaged cylinder.
1. Broken drive shaft.
2. Engine/pump misalignment.
3. Gear sections damaged.
4. Damaged shaft seal.
5. Plugged oil breather.
1. Damaged control valve
1. Hydraulic fluid too cold.
2. Hydraulic fluid too thick.
3. Hydraulic fluid contaminated.
4. Damaged control valve.
BE-LS25Ex
POSSIBLE REMEDY
1. See authorized service dealer.
2. Disconnect hydraulic hoses, remove
shipping plugs and reconnect hoses.
3. See authorized service dealer.
4. Correct engine/pump alignment
as necessary.
5. See authorized service dealer.
6. See authorized service dealer.
7. Flush and clean hydraulic system.
8. Fill oil or bleed air.
9. See authorized service dealer.
10. Flush and clean hydraulic system.
1. See authorized service dealer.
2. Make certain pump inlet hoses are
clear and unblocked. Use short,
large diameter inlet hoses.
3. See authorized service dealer.
4. See authorized service dealer.
5. Fill oil or bleed air.
6. Drain oil, clean reservoir and refill.
7. See authorized service dealer.
8. See authorized service dealer.
1. See authorized service dealer.
2. See authorized service dealer.
1. See authorized service dealer.
2. See authorized service dealer.
3. Make certain pump inlet hoses are
clear and unblocked.
4. Fill oil or bleed air.
5. Fill oil, clean reservoir and refill.
6. See authorized service dealer.
7. Do not attempt to split wood against
the grain.
8. See authorized service dealer.
1. See authorized service dealer.
2. Correct alignment as necessary.
3. See authorized service dealer.
4. See authorized service dealer.
5. Make certain reservoir is properly vented.
1. See authorized service dealer.
1. Warm up engine.
2. Replace hydraulic fluid.
3. Replace hydraulic fluid.
4. See authorized service dealer.