Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLING (CONT.)
3. Adjust the engine side of the coupler shaft to make sure the engine key fits into the slot of the coupler shaft,
tighten the set screw just loosened.
4. If needed, slowly pull on the engine starter cord to rotate the engine shaft to align the fixing holes on the
engine. Also make sure the open side of the pump mount facing down
5. Secure the pump assembly onto the engine using the bolts 5/16-24 and M8 washers. Tighten the hardware
using a 1/2" wrench.
NOTE: In the Hardware Kit #5-2 or 5-2, you have one O Seal Ring (Ø15*1.9), which is a spare O-Ring to be used
in STEP 6: Connecting hydraulic hoses" section if you can't find one sitting in the fitting slot on the
reservoir tank, when you attach the oil return hose (3) to the reservoir tank.
REF NO.
6-1
6-2
Engine Shaft Key (Engine Assembly)
Pump Mount Assembly - 11 GPM (Hardware Kit #8-1) (22/25/28T)
7-1
Pump Mount Assembly - 16 GPM (Hardware Kit #8-2) (30/35T)
7-2
Hex Head Bolt - 5/16-24 (Hardware Kit #8-1/8-2)
7-3
Spring Washer - 5/16 (Hardware Kit #8-1/8-2)
7-4
Flat Washer - M8 (Hardware Kit #8-1/8-2)
REF NO.
9
Hex Head Bolt - M8x40 (Hardware Kit #5-1) (22/25/28T)
10-1
Hex Head Bolt - M10x40 (Hardware Kit #5-2) (30/35T)
Flat Washer - M8 (Hardware Kit #5-1) (22/25/28T)
10-2
Flat Washer - M10 (Hardware Kit #5-2) (30/35T)
Lock Nut - M8 (Hardware Kit #5-1) (22/25/28T)
10-3
Lock Nut - M10 (Hardware Kit #5-2) (30/35T)
Vibration Isolator - Ø9 (Hardware Kit #5-1) (22/25/28T)
10-4
Vibration Isolator - Ø11 (Hardware Kit #5-2) (30/35T)
//
O Seal Ring - Ø15*1.9 (Hardware Kit #5-1/5-2)
DESCRIPTION
Engine (Engine Assembly)
DESCRIPTION
Engine Pump Assembly
BE-LS25Ex
QTY
1
1
1
4
4
4
QTY
1
4
8
4
4
1
Publicité
