Publicité
Les langues disponibles
Les langues disponibles
SET-UP
GAS & OIL FILL UP
Service the engine with gasoline and engine oil as instructed in the engine manual packed with your log splitter.
Read the instructions carefully.
WARNING
the vapors are explosive. Never fuel the machine indoors or while the engine is hot or running.
NOTE: Your log splitter may be shipped without engine oil. You MUST check the oil level before operating.
Be careful not to overfill. Gasoline can be added to the engine when the log splitter is in either the
horizontal or vertical position. However, it may be easier when the splitter is in the vertical position.
ADJUST HANDLE RELEASE LEVER
You log splitter is equipped with an external pressure system which is attached under the valve bracket.
When you set up the machine and try it, you will see the back of the wedge hits the handle release lever when
the wedge is full retracted. The control handle is then kicked back form reverse position to the neutral position
automatically.
The lever may need to be adjusted if the wedge is fully retracted and the control lever does not automatically
kick into neutral.
To adjust the handle release lever, See Figure 12.
1. Loosen the Jam Nut using a 14mm wrench.
2. Screw the adjusting nut counter-clockwise to allow it to contact with the wedge as soon as the wedge is
fully retracted.
3. Tighten the jam nut after adjusting.
LUBRICATE THE BEAM
Lubricate the beam area (where the splitting wedge will slide) with engine oil. Do not use grease. See Figure 13.
Use extreme care when handling gasoline. Gasoline is extremely flammable and
BE-LS25Ex
Publicité
