Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLING (CONT.)
Step 5: Install the beam assembly. See Figure 8.
1. Stand the beam upright on a flat level. Two or more people are recommended to assist with raising and
lowering the beam as it is very heavy. Have a helper support the beam as you perform the following steps.
Be sure to keep hands away from any possible pinch points.
2. Remove the clevis pin and spring clip from the beam support bracket on the tank. Position the tongue/tank
assembly sot hat the beam support bracket is in between the two tabs on the beam.
3. Slide the clevis pin through the aligned holes and secure with the spring clip. You may need another helper
lift up the tongue for the holes to align.
4. Leave the beam in the vertical position for continual assembling steps.
WARNING
Having a second person assist with raising or lowering the beam is recommended.
Be sure to keep hands away from any possible pinch points.
REF NO.
11
take extra care when raising and lowering the beam as it is fairly heavy.
DESCRIPTION
Beam Assembly
BE-LS25Ex
QTY
1
Publicité
