Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLING
NOTE: Due to the weight/size of the log splitter, it is recommended that two or more adults be present to assist
with the assembling. Some lifting tools such as hoist, crane, jack, etc. are recommended too.
ASSEMBLING TOOLS NEEDED:
• Wrench 13mm (x2)
• Wrench 14mm (x2)
• Wrench 16, 17, 18, 19, 27, 32mm (x1 ea.)
• Wrench 1/2" (x1)
• Adjustable Wrench (x1)
• Needle Nose Pliers (x1)
• Allen Wrench 3mm (x1)
• Flat Head Screwdriver (x1)
• Soft Faced Hammer (x1)
• Thread Locking Compound (x1)
Step 1: Install the two wheels. See Figure 4.
1. Raise the reservoir tank assembly o the ground on some blocks before mounting. Remove the plastic
shipping caps from the wheels and position the wheels onto the wheel axles.
2. Screw the castle nuts onto the axles and tighten with an adjustable wrench to seat the bearings. Then back
the castle nuts o one half turn and snug them up to the bearings by hand, so they line up with the hole in
the axle.
3. Insert the split pin into the slot of the castle nut and the hole in the axle, then bend the ends of the pin with
needle nose pliers keeping it close to the castle nut so the dust cap fits over it.
4. Tap the dust caps onto the wheel using a soft faced hammer.
REF NO.
DESCRIPTION
1
Reservoir Tank Assembly
2
Pneumatic Tire/Wheel
3-1
Castle Nut - 1-14 (Hardware Kit #2)
3-2
Split Pin - Ø4x50 (Hardware Kit #2)
3-3
Dust Cap (Hardware Kit #2)
BE-LS25Ex
QTY
1
2
2
2
2
Publicité
