ASSEMBLING (CONT.)
Step 7: Install the log tray assemblies. See Figure 10.
1. Lower the beam to horizontal position. Please refer to "Beam Operating Positions" section in this manual.
2. Position the log tray frames onto the beam as shown below and secure it with the M10 hardware loosely.
3. Tighten the M10 hardware using a 16mm wrench on the bolts and a 17mm wrench on the lock nuts.
REF NO.
12
13-1
Hex Head Bolt - M10x45 (Hardware Kit #6-1)
13-2
Flat Washer - M10 (Hardware Kit #6-1)
13-3
Lock Nut - M10 (Hardware Kit #6-1)
DESCRIPTION
Log Tray Assembly
BE-LS25Ex
QTY
2
4
8
4