Publicité
Les langues disponibles
Les langues disponibles
TRANSPORTING
1. Lower the beam to its horizontal position. Make certain the beam is locked securely with the horizontal
beam lock.
2. Pivot the flip-down stand up to transporting position.
a. Pull out the lock handle of the stand and rotate it up. The stand will be secured horizontally with the
tongue automatically.
b. Have a helper to support the tongue, or use a wheeled trailer jack to raise the tongue (optional accessory
from the manufacturer).
3. Pull the latch on the hitch coupler up, position the coupler over onto the tow ball behind your towing vehicle
and then close the latch to lock the ball securely. See Figure 20.
a. If the coupler hitch is too high and does not fit onto the ball, turn the adjustment nut one turn
counter-clockwise.
b. If the coupler hitch is too loose on the ball, turn the adjustment nut one turn clockwise, then recheck and
adjust accordingly.
4. Attach the safety chains to the towing vehicle crossing each other under the tow ball, ensuring there is
enough slack for turning.
5. Insert the locking pin into the hole in the latch assembly and lock with the spring clip.
WARNING!
Do not tow faster than 45 mph and check the local, state and federal requirements before towing on
any public road.
NOTE: Use caution when backing up. Using a spotter outside the vehicle is recommended.
BE-LS25Ex
Publicité
