Specifications - Allmand NIGHT-LITE GR Série Manuel D'utilisation

Keeping the light tower clean is important to ensure proper
operation. Dirt and dust buildup acts as an insulator and may
cause the engine, generator and light assemblies to operate
at excessively high temperatures.
Use the following as cleaning guidelines:
1. Clean the light tower trailer to remove all dust, dirt or
other foreign material.
2. Clean the light tower and light fixture assemblies with a
damp cloth or sponge.
3. Clean all electrical wiring and components by hand using
non-corrosive cleaner.
4. Clean the inside of the control compartment.
Models and Serial Numbers
Model and serial number information is required for product
support and repair parts. Following are the model and serial
number locations of the primary components.
Trailer
The serial number plate for the light tower trailer is located on
the left side of the trailer tongue (A, Figure 22).
22

Specifications

Overall Dimensions
Dimension
Length - Towing Transport 9 ft - 6 in
Width - Towing Transport 4 ft - 0.25 in
Width - Outriggers Deployed 7 ft - 10 in
Height - Towing Transport 8 ft - 2 in
Height - Tower Fully Elevated 23 ft - 0 in
Shipping Weight 835 lbs
Gross Vehicle Weight Rating 1200 lbs
(GVWR)
Trailer
Specification
Gross Axle Weight Rating 2200 lbs
(GAWR)
Tire Size and Rating ST175/80R13 Load Range 'C'
Imperial Metric
2,90 m
1,22 m
2,39 m
2,49 m
7,01 m
379 kg
544 kg
Imperial Metric
998 kg
Trailer
Rims 13 x 4.5 JJ with 0.0 inch offset
Cold Tire Inflation Pressure 36 psi
Max On-Road Speed 65 mph
Max Off-Road Speed 20 mph
Frame Structure Formed welded steel design
Axle Tubular design with 1.5 - 2.0 inch (38,1 -
50,8 mm) camber
Hubs (5) 1/2-20 UNF studs on a 4.5 inch (114,3
mm) bolt circle
Springs Elliptical springs - 3 leaf
Available Hitches
Trailer Road Lighting Stop, turn, tail, side markers, illuminated
license plate bracket
Trailer Road Lighting 4-way flat connector
Connector
Lifting Eye - Rated Capacity 1500 lbs
Forklift Pockets / Tie-Down 2 each side
Points
Outrigger and Stabilization Left and right side outriggers with adjustable
System screw type jacks, 1 adjustable screw type
tongue jack
Maximum Wind Speed 50 MPH
- Tower Elevated and
Outriggers and Stabilizers
Deployed
Light Tower
Structure Four-section tubular steel design
Actuation Standard - Manual winch
Guide Pads Polyethylene self-lubricating
Power Cable Coiled cable secured at top of sections to
minimize possibility of tangling
Tower Rotation Complete tower rotates 345°
Light Fixtures
LED
Color Temperature
Power Consumption - per
Fixture
Lumens - per Fixture
Electrical
Frequency (Hz)
Volts
Amps
Available Outlets 20A 120V duplex GFCI outlet (NEMA 5-20R)
248 kPa
105 km/h
32 km/h
2 inch (50.8 mm) ball coupler
680 kg
80 km/h
5000K
250 W
38081
60
120
16.7
19