Allmand NIGHT-LITE GR Série Manuel D'utilisation page 3

DANGER
Electrocution Hazard
• Always check overhead wires and obstructions before
raising or lowering the light tower.
• Always obey the rules or instructions for your work
site and state, province and national electric code for
maintaining a safe distance from overhead wires.
• High voltage is present when the unit is connected to
a power source. Never attempt to service electrical
components while the unit is connected to a power
source.
• Do not operate the light tower if the insulation on the
electrical cord or other electrical wiring is cut or worn or
if bare wires are exposed. Repair or replace damaged
wiring before operating the light tower.
WARNING
Unsafe Operation Hazard
• Never permit anyone to install or operate the equipment
without proper training.
• Read and understand this Operator's Manual and any
other component manuals before operating or servicing
the light tower to make sure that safe operating
practices and maintenance procedures are followed.
• Safety signs and decals are additional reminders for
safe operating and maintenance techniques.
WARNING
Fall Hazard
• Never carry riders on the equipment.
WARNING
Modification Hazard
• Never modify the equipment without written consent of
the manufacturer. Any modification could effect the safe
operation of the equipment.
WARNING
Exposure Hazard
• Always wear personal protective equipment, including
appropriate clothing, gloves, work shoes, and eye and
hearing protection, as required by the task at hand.
WARNING
Rollover Hazard
• Do not raise, lower or use the light tower unless all
outriggers and jacks are positioned on firm ground.
• Never move or reposition the light tower while the light
tower is extended in the vertical position.
WARNING
Alcohol And Drug Hazard
• Never operate the light tower while under the influence
of alcohol or drugs, or when ill.
WARNING
Flying Object Hazard
• Always wear eye protection when cleaning the
equipment with compressed air or high pressure water.
Dust, flying debris, compressed air, pressurized water
or steam may injure your eyes.
WARNING
Burn Hazard
• Some of the surfaces become very hot during operation
and shortly after shutdown.
• Keep hands and other body parts away from hot
surfaces.
• Handle hot components with heat resistant gloves.
3