Allmand NIGHT-LITE GR Série Manuel D'utilisation page 15

15
Rotating The Light Tower
WARNING
Failure to tighten the light tower locking knob may cause
the light fixtures to swing inadvertently, especially in windy
conditions or during transport, and could result in death
or serious injury. Always tighten the tower locking knob
securely after turning the light tower.
CAUTION
Rotating the light tower will cause the light fixtures to swing,
and could result in minor to moderate injury. Be careful to
rotate the tower slowly, and be aware of the light fixtures
while rotating the tower.
1. Loosen the light tower rotation locking knob (A, Figure
16).
2. Use the handles (B, Figure 16) to rotate the light tower in
the desired direction.
3. Tighten the light tower locking knob.
4. When lighting operations are complete, rotate the
light tower to the transport position, with the fixtures
facing straight back toward the rear of the light tower
trailer. Tighten the light tower rotation locking knob.
16
Raising and Lowering the Light Tower
DANGER
Electrocution Hazard
Raising the light tower in the presence of electrical power
lines will result in death or serious injury. Always check
overhead wires and obstructions before raising or lowering
the light tower.
WARNING
Rollover Hazard
Before raising, lowering or operating the tower lights, the
trailer must be set up, leveled and stabilized. See Leveling
and Stabilizing the Light Tower.
WARNING
Crush Hazard
Standing under the light tower while raising or lowering
could result in death or serious injury. Make sure that there
are no persons near the light tower when raising or lowering
the light tower.
Raising the Light Tower
1. Before raising the light tower, adjust the tower lights to
the desired work position. See Adjusting the Lights.
15