Teacher/Pupil/Simulator-Mode - Multiplex Cockpit SX 7 Mode D'emploi

13. Teacher/pupil/simulator mode
With the COCKPIT SX M-LINK, you can operate wireless teach-
er/pupil and simulator mode.
Using the button, call up the
teacher/pupil/simulator menu.
Teacher mode
For teacher mode, the optionally available "Copilot" com-
ponent must be used (ord.No. # 45184). It can be fitted
into any socket labeled with "Module" in the transmitter
interior. Using the Torx key included, remove the 6 cas-
ing screws which sit in holes of approx. 7mm diameter.
Carefully lift up the back wall; the connecting wire to the back
wall of the transmitter should not be subjected to any tensile
strain. Insert the Copilot component and secure it with the
screw included. Carefully replace the back wall, paying close
attention to the connecting wire; it should not be anywhere
near the moving parts of the joysticks. Screw the back wall of
the transmitter back on again.
· Select "Teacher" and activate the teacher mode in the
following menu.
· Switch on the pupil.
If teacher and pupil have not yet been connected to each
other, the following steps must be carried out:
· Start the pupil search on your transmitter.
· Start pupil mode on the pupil transmitter ("Binding" on
older devices)
As soon as the pupil has been recognized, the notification "Pu-
pil connected" appears.
· Select which control functions are to be transferred to the
pupil.
· You can start and stop the transfer by pressing the
"TEACHER/VARIO" button.
A special feature is the "automatic transfer function" - if the
teacher must quickly intervene, the teacher can gain complete
control of the model immediately simply by moving the joysticks.
Pupil mode
The Cockpit can be used as a pupil transmitter with every
MULTIPLEX teacher transmitter which is equipped with a Copi-
lot or teacher-pupil-stick.
· Select "Pupil".
· If teacher and pupil transmitters are not yet connected, the
notification "No telemetry signal" appears.
· Bring the Copilot/teacher-pupil-stick into pupil search mode
("Binding") on the teacher transmitter.
· Press "Start"
· After the teacher has been found, pupil mode can be
started.
Simulator mode
Wireless simulator mode is possible using the optionally avail-
able MULTIflight stick (ord.No. # 85147).
To start simulator mode, proceed as follows:
· Select "Simulator mode".
· If COCKPIT and MULTIflight stick are not yet connected, the
notification "No telemetry signal" appears.
· Bring the MULTIflight stick into the transmitter search mode
("Binding")
· Press "Start"
· Once the MULTIflight stick has been recognized, pupil
mode can be started.

37