DS Produkte 00052 Mode D'emploi page 45

for every 15 additional minutes. However, do not exceed the MAX mark. To enhance
the fl avour of food, e.g. broth or a mixture of water and wine can also be used instead
of water.
3. Place the mixing bowl in the motor unit.
4. Place the steamer adapter on the mixing bowl. Follow the instructions in the chapter
"Using the accessories properly", section "Steamer unit". In the process, make sure
that the adapter is correctly seated.
5. Fill it with the desired food that is not packed down. Make sure that some of the vents
are not obstructed to allow the steam to rise. If necessary, insert the intermediate
panel in the steamer adapter.
6. Place the lid on the steamer adapter. Make sure that it is correctly fi tted to prevent too
much steam from being released and food from being improperly cooked.
7. Turn on the motor unit (by fl ipping the On/Off switch to position I).
8. Set the cooking time and temperature, which the liquid in the mixing bowl should be
heated to.
9. Push the button and the device will start working. You can also switch on the
cross-blade adapter to the speed level 1 to 2.
10. If, before the set cooking time has elapsed, you would like to check whether the food
is done, push the
11. Gently tip the lid forward so that the steam can escape to the back. Make sure that
the condensation drips into the steamer adapter by holding it in the middle over it. You
can then carefully remove the lid.
12. To remove the steamer adapter, turn it slightly counterclockwise. Lift it, wait a few
seconds until the steam condenses and has dripped into the mixing bowl before you
place it on a heat-resistant base.
13. If you would like to continue steaming, fi t the steamer unit back on the mixing bowl
and push the
14. To turn off the device, set the On/Off switch to the 0 position and then pull the mains
plug out of the socket.
15. Take the steamer unit off of the mixing bowl as described with step 12. Then carefully
lift the mixing bowl out of the motor unit and pour the hot water out.
Weighing
ATTENTION!
■ Make sure that the device is arranged in a stable position on a level work surface with
the suction feet fi rmly attached to ensure the scale is able to display the measure-
ment results as accurately as possible.
You can weigh up to 2.5 kg on the scale. It also has a tara function. With the
button, you can switch the scale on and off as well as activate the tara function.
1. Turn on the motor unit by fl ipping the On/Off switch on the bottom of the motor unit
to position I.
2. Place what you would like to weigh on the scale.
3. Push the scale button and the weight will appear in grams.
button to stop the device and the timer.
button. The timer will continue to run.
45 EN
scale