WAGNER FINECOAT 9900 PLUS Mode D'emploi page 5

FC9900 Plus
3
PREPARING THE COATING MATERIAL
Observe the manufacturer's instructions for the use of the
coating material on the paint tin or on the technical instruction
sheet.
3.1
COATING MATERIAL PURITY:
An absolute pre-condition for the trouble-free operation of the
fine-spray system is that the coating material is uncontaminated.
If you have doubts as to the purity of the coating material, we
recommend that you first filter it through a fine sieve.
4
STARTING OPERATION
Before connecting to the mains supply make
i
sure that the mains voltage corresponds to the
operating voltage on the rating plate. The unit
must be connected with a properly earthed
shockproof socket.
1. Screw air hose end (anti-kink spring) onto the turboblower.
Couple air hose to the paint spray gun.
2. Open closing lever on the paint container, remove paint
container.
3. Fill paint container with coating material.
4. Check that the paint container seal is clean and is seated
correctly.
5. Clip the container onto the spray gun and secure with the
closing lever.
6. Switch the turbo-blower on.
7. Point the paint spray gun at the object to be sprayed.
8. Determine the settings for the spray pattern, spray jet
width, amount of material, amount of air and ascending
feed pipe settings, see fig. 2 - 8 and the description page
5/6.
9. Operate trigger on the paint spray gun.
PREPARING THE COATING MATERIAL / STARTING OPERATION
4.1
SETTING THE FC9900 PLUS SPRAY GUN
SPRAY PATTERN SELECTION (FIG. 2)
A = vertical flat jet for horizontal surfaces
B = horizontal flat jet for vertical surfaces
C = Round jet for corners and edges and places difficult to
access.
A
SETTING THE REQUIRED SPRAY PATTERN (FIG. 3)
Turn the air cap (1) to the required spray pattern position.
Never pull trigger while adjusting the air cap
settings.
Attention
1
B C
5