WAGNER FINECOAT 9900 PLUS Mode D'emploi page 15

FC9900 Plus
10
MATERIAL REDUCTION/PROJECTOR SET CHART
Before spraying, the material being used must be thinned with an appropriate solvent and the proper projector set must be installed.
It is always best to follow the material manufacturers recommendations and thinning procedures.
There are two simple methods of measuring the proper thickness of a material:
1. Dip a paint stick into the material and remove it, watching carefully as the material runs off. When the material begins to form
drops, the drops should fall about 1 second apart.
2. Use a viscosity cup (P/N 0153165). Dip the cup into the material and remove it. Use a watch or clock to time how long the
material drains from the cup in a continuous stream. Once the continuous stream breaks, stop timing and refer to the table
below. Add the appropriate solvent and continue testing until the proper thickness is reached for the type of material you are
using.
MATERIAL
Solvent-based lacquer paints
Water-soluble lacquer paints
Wood preservatives (scumble, mordants, etc).
Multi-color effect materials, multi-color paint
Texture and effect paints
VISCOSITY DIN-S (4 MM DIN CUP)
15 - 45
observe manufacturer's instructions
undiluted
observe manufacturer's instructions
observe manufacturer's instructions
MATERIAL REDUCTION/PROJECTOR SET CHART
PROJECTOR SET
3 - 4
4 - 5
2 - 3
6 - 7
5 - 6
15