Pit Boss SPORTSMAN Mode D'emploi page 9

The Grill Probe measures the internal temperature of the smoker.
When the Target temperature is adjusted, the Grill Probe will read
the Actual temperature inside the smoke cabinet and adjust to the
desired Target temperature. To adjust the desired Target temperature
of the grill, follow the steps below:
1. Press the Controller Knob. The Target temperature will blink to
show it is active. (A)
2. Turn the Controller Knob to change the Target temperature value
to your desired temperature. (B)
3. Once the desired Target temperature is reached, lock it in by
pressing the Controller Knob (C). The Temperature Readout will
return back to the Actual Temperature.
The meat probe measures the internal temperature of your meat in the grill, similar to your indoor oven. Plug-in the
meat probe adapter to the meat probe connection port on the Control Board and insert the stainless steel meat probe
into the thickest portion of your meat and the temperature will be displayed on the control board. To ensure the meat
probe is connected properly to the connection port, feel and hear it snap into place.
NOTE: When placing the meat probe into your meat, ensure the meat probe and meat probe wires avoid direct contact
with flame or excess heat. This can result in damage to your meat probe. Run the excess wire out the hole located on the
left side of the main grill or the top of the main grill (near the grill lid hinge). When not in use, disconnect from the meat
probe connection port and place aside to keep protected and clean.
WWW.PITBOSS-GRILLS.COM
SETTING THE TEMPERATURE
USING THE MEAT PROBES
9
A C
B
PIT BOSS® GRILLS