GE Spacemaker Notice D'installation page 3

Installation Preparation-Enclosure
PREPARE DISHWASHER ENCLOSURE AND
SINK LOCATION
• Water line to sink faucet and drain from sink can
be run through Area "A."
• Hot water line to dishwasher is installed in Area "B."
• Garbage disposer, water lines to faucet, waste
• Sink opening for garbage disposer must be
dimensioned as shown (7-1/2")in Area "C." This will
provide clearance for disposer and plumbing in
Area "C" when using either single or double bowl
sink. Refer to Figure A below and Figure F1 on
page 6.
/Wall
trap, air gap and water shut-off valve are installed
in o 22" wide cabinet, Area "C".
Countertop: 1-1/2" Hin, Thick
ii
II
Toekick
Area
/
24"
,I--A L--IX
Floor
Figure A
PREPARE CABINET CUTOUT FOR SINK:
r!'wkv, v/.,1 ;,_ _, I I_, [ €1
To reduce the risk of shock, fire, or injury to
persons, the installer must ensure that the
dishwasher is completely enclosed at the
time of installation.
Para reducir el riesgo de choque, incendio
o lesi6n a personas, el instalador se
debe cerciorar de que la lavadora est_
completamente cerrada en el momento
de la instalaci6n.
./2" Max_-
1" Max. To
3/4" Min.--,- I _ - Sink Flange
t
6" lax. 10-1/4" MAX.
PLUHBING
DEPTH
Hin. I.R.
34-1/4
!1/4" 1-1/2" Plumbing
Close Elbow
Dishwasher
Side View
...... Hax_ B I
__ 24" Min. __
Cabinet
• The cabinet opening must have o minimum width
and depth of 24" and height of 34-1/4" + 1/4".
• This dishwasher fits under o special sink with o
depth of 6" or less in o 1-1/2" countertop.
The dishwasher must be futlg enclosed on the top,
sides and buck.
The dishwasher must not support ong part of the
enclosure.
Wall
_20-i/2" Max._ /
Sink Bo_
Jl
Front
Flange
Dishwasher
Gap
Sink
Installation
8" X 20"
II ,,,," I
Adjacent Cabinet
if_, _
Zear Cutout
II / Cabinet Side/
_ / Adjacent to D/W
_- 24" min
Figure B
24" Min.
Cabinet
Y
Note: A gap between the dishwasher tub front flange and
the front of the base cabinet mag result due to either
the cabinet being less than 24" deep or the sink bowl
not being installed to specifications.
If the gap is more than 3/4", the sink bowl must be
relocated to meet specified dimensions.