Télécharger Imprimer la page

GE Spacemaker Notice D'installation page 14

Publicité

Les langues disponibles

Les langues disponibles

Dishwasher Installation
STEP 19: DISHWASHER WET TEST
CHECK LIST
[] Turn on power supply or if power cord is used,
plug it into the wall outlet.
[] Latch dishwasher door.
[] Press the "Normal" pad, and then turn control dial
just enough to start dishwasher. Be careful not to
turn the dial past the first water fill. Dial should
point to "Hot Start Option".
Options
Q
Appearance varies by model.
[] Check to be sure that water enters the dish-
washer. This could take up to 4 minutes.
If water does not enter the dishwasher try the
following to correct the problem:
- Check to be sure that the water is turned on
- Lightly tap the flood float cover to
dislodge a stuck flood float.
Cover
- Check the electrical connection
to the water
valve. The red electrical connector should be
plugged into the dishwasher water valve. If it is
not plugged in, turn off electrical power to the
dishwasher. Plug the red connector
into the dish-
washer water valve and then restore power.
Red Connector
[] Check for leaks under the dishwasher. If a leak is
found, turn off power, tighten connections
and
restore power.
[] Check for leaks around the door. A leak around
the door could be caused by the dishwasher door
rubbing or hitting adjacent cabinets. Reposition
the dishwasher if necessary. See Steps :1_:1_,
12
and 13.
[] Most dishwasher
models will drain about 3 min-
utes after the first fill. Check the drain line for
leaks when dishwasher drains. If leaks ore found,
turn off power, correct as necessary and then
restore power.
[] Open the dishwasher door and make sure most
of the water has drained. If the water does not
drain, check to be sure disposer plug has been
removed and/or air gap is free of debris.
[] Let the dishwasher run through another fill and
drain cycle. Check again to be sure there ore no
leaks.
[] At the end of the second drain, unlatch the door
and rotate the dial to the "OFF" position.
14

Publicité

loading