Cub Cadet PRO X 636 Manuel De L'opérateur page 9

Operator's Platform Suspension
MOWERS WITH 48, 54 OR 60 INCH DECKS
The mower operator's platform suspension firmness is adjustable. Moving the
suspension lever (a) to the top position (b) provides a firmer suspension. The lower
setting (c) provides a softer suspension (Figure 7).
1. Ensure the mower is unoccupied with the engine off and parking brake engaged.
2. Move the suspension lever up and away from the mower.
3. Move the suspension lever to one of three suspension settings.
4. Lower the suspension lever into the suspension setting. Ensure the suspension
lever fully engages the setting before releasing the lever.
(b)
(c)
Figure 7
SET-UP
MOWERS WITH 36 INCH DECKS
The mower operator's platform suspension firmness is adjustable. Moving the two
adjustment rods to one of four combinations (Figure 8 inset) will provide a firmer or
softer operator's platform suspension.
1. Remove the rear panel. Refer to Removing/Installing the Rear Panel, Rear Panel
with Quarter Turn Latches.
2. Locate the two adjustment rods (a).
NOTE: Refer to Figure 8 inset to see the stop position locations for the desired
suspension firmness.
3. Moving one adjustment rod at a time, slightly pull and lift the adjustment rod off
of the ball stud (b).
4. Push or pull the adjustment rod until the loop is over the correct ball stud for the
(a)
desired suspension firmness.
5. Lower the adjustment rod down until the loop is fully seated onto the stop post.
6. Repeat STEPS 4 - 5 to reposition the remaining adjustment rod, if necessary.
(a)
(b)
9
OR
Figure 8
Firm
Soft