Cub Cadet PRO X 636 Manuel De L'opérateur page 10

A
D
E
G
NOTE: This Operator's Manual covers several models. Mower features may vary by
model. Not all features in this manual are applicable to all mower models and the
mower depicted may differ from yours.
NOTE: References to LEFT, RIGHT, FRONT, and REAR indicate that position on the
mower when facing forward while standing on the operator's platform.
FEATURES
A. DRIVE CONTROL LEVERS
The RH (Right Hand) and LH (Left Hand) drive control levers are located on each side
of the control panel.
Each drive control lever controls the respective transmission. Consequently, these
levers control all of the mowers movement. Driving and steering using these control
levers is quite different from conventional mowers and will take practice to master.
Refer to Practice Operation (Initial Use) section for further instructions.
B. PARKING BRAKE LEVER
The parking brake lever is located to the left of the control panel. Pull
the parking brake lever back to engage the brake (ON position " ")
or push the parking brake lever forward to disengage the brake (OFF
position " ").
IMPORTANT! The parking brake on mowers with a 36 inch mowing
deck uses a brake wedge that may require adjustment as the rear wheel tire tread
wears. Refer to Parking Brake Check/Adjustment - 36 Inch Deck Only.
C. SUSPENSION LEVER (IF EQUIPPED)
Used to select suspension firmness of the operator's platform.
OPERATION
I
H
J
K
B
C
U
T
O
N
M
L
H
Q
R
Q
S
Figure 9
D. DECK LIFT HANDLE
The deck lift handle is located on the right side of the mower and is used to raise and
lower the mower deck.
Depress the button on the end of the handle and push downward to lower the deck,
or pull upward to raise the deck. When the desired height is attained, secure the pin
in the desired index hole and release the button on the handle.
NOTE: Make certain the deck is secured and the pin is fully inserted into the deck
height index. The pin is keyed to help keep it in place and fits into the slotted holes
on the deck height index.
NOTE: The deck lift handle must always be above the pin, never hang the deck lift
handle from the pin when mowing.
E. DECK HEIGHT INDEX
The deck height index consists of several holes located on the right of the mower.
Each hole corresponds to a 1⁄4 inch (6.4 mm) change in the deck height position
ranging from 1-1/2 inch (38.1 mm) at the lowest setting to 4-1/2 inch (114.3 mm) at
the highest setting. Insert the connected pin to select the desired deck height.
F. TRANSPORT LOCK (NOT SHOWN)
The transport lock is the highest setting on the deck height index, and is used to lock
the deck into the transport position. Use the deck lift handle to engage or disengage
the transport lock.
NOTE: Do not mow with the deck in the transport position.
NOTE: Mowers with 48, 54 or 60 inch Mowing Decks - Do not mow with the deck in
the transport position.
10
N