Cub Cadet PRO X 636 Manuel De L'opérateur page 18

MAINTENANCE SCHEDULE
Check gasoline level
Check hydraulic hoses for leaks
Check tires & tire pressure
Check deck, mower and hydro
drive belts
Check blades and blade
bolt tightness
Check safety switches for
proper operation
Check parking brake for
proper operation **
Check fluid level in transmission oil
expansion reservoir
Check/Clean Engine Intake Screens
& Cooling Fans *
Check/Clean Exhaust Manifold,
Muffler Pipe & Muffler Shields *
Check/Clean Top & Underside of
Deck, Under and Around Spindle
Covers & Belt Area *
Check/Clean Around Fuses,
Wiring and Wiring Harnesses *
Check/Clean Around
Transmission, Axle and Fans *
Blow out/clean the engine/
pump control
Blow out/clean the operator's
platform area
Lubricate wear points (see chart)
Clean engine cooling fins &
external surfaces *
Change hydrostatic fluid &
filter in transaxles ^
* — Perform more frequently under dusty conditions.
** — Parking Brake on 36 Inch Deck Models Only: Parking brake uses brake
wedge that will require adjustment as the tire wears. Refer to Parking Brake
Check/Adjustment - 36 Inch Deck Only on page 21.
^ — After first 300 hours, change hydrostatic fluid and filter in transaxles.
PRODUCT CARE
Before Every Every Every
Each 25 50 500
Use Hours Hours Hours
OIL CHART
Apply a few drops of SAE engine oil, grease or use a spray lubricant. Apply the oil
After
to both sides of pivot points. Wipe off any excess. Start engine and operate mower
Each
Use briefly to ensure that oil spreads evenly.
Number of Oil Points
4
2
4
2
6
2
1
2
4
4
2
1
1
1
1
Hydraulic Fluid
• Cub Drive System Fluid Plus (Shell TT-SB)
General Purpose Lubrication:
Use any NLGI grade 2 multi-purpose grease. Shell Albida EP2 is recommended.
Shell Albida EP 2 is a red-colored multi-purpose grease designed for heavy-duty
bearing applications. It has high base oil viscosity for mechanical stability, has been
formulated for high load, low-speed applications, and has excellent lubrication and
corrosion protection.
NOTE: This Operator's Manual covers several models. Mower features may vary by
model. Not all features in this manual are applicable to all mower models and the
mower depicted may differ from yours.
MAINTENANCE
Before performing any maintenance or repairs, disengage the PTO, move
the drive control levers into the neutral position and engage the parking
brake. Stop the engine and remove the key to prevent unintended starting.
POST-OPERATION MOWER CARE
After each operation of the mower, the following procedures should be implemented
to extend the life of your mower and ensure safe operating conditions.
Failure to follow these recommendations may result in serious injury to
yourself or others and may cause damage to the mower.
18
Description
DAILY
Deck Suspension Pivots
Rear Deck Stabilizer Pivots
Height Adjustment Turnbuckle Clevis Pin
Height Adjustment Handle Pivots
Deck Lift Linkage Pivots
Deck Lift Handle Pivots
Deck Lift Handle Pin
Deck Frame Up-and-Down Pivots
WEEKLY
Operator's Platform Linkage Pivot Points
Speed Control Linkage Rod End Bearings
Pump Control Lever Pivots
Operator's Platform Suspension Adjustment
Lever Pivot
Brake Lever Pivot
Brake Lever Pivot Clevis Pin
Brake Lever Control Rod Pivot
WARNING
DANGER