Invacare ScanBeta NG Manuel D'utilisation page 12

2.2.2 Mounting the bed end plates
1. Lift the bed end plate so that the guide pins in the top frame fit
into the holes on the lower edge of the bed end plate.
2. Swing the upper edge of the bed end plate in towards the top
of the bed end pieces so that the holes in the top of the cot end
plate are flush with the holes in the bed end piece.
3. Secure the cot end plate using the 2 screws provided.
4. Repeat steps 1-3 for the opposite bed end plate.
5. Please ensure that the bed end plate is securely mounted and
tightened.
2.2.3 Mounting the fixed bed sides
1. Place the fixed bed side so that the guide pins in the side frame
tube can be guided into the brass bush on the bottom of the
lattice.
2. Swing the upper edge of the fixed bed side in towards the bed
end piece, so that the holes in the brass bush are flush with the
holes and the guide pin fits.
3. Secure the fixed bed side using the two screws provided.
4. Please ensure that the fixed bed side is securely mounted and
tightened.
UM_1542073_UK_DA_ver01.indd 11
1
3
1
11
3
2
2011-10-18 10:02:20