Removing The Mattress Support; Mounting And Removal Of Motors - Invacare ScanBeta NG Manuel D'utilisation

Masquer les pouces Voir aussi pour ScanBeta NG:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

5.3 Removing the mattress support

1.
Please ensure that the motors are removed, whether they are mounted directly on the mattress support, or between the
mattress and the base. These must be removed before the mattress support can be removed. (See Chapter 5.3 for removal of
motors).
2.
Release the two spring locks by pulling the red button completely out and turning it 45° clockwise.
3.
Lift the cot end closest to the snap spring locks.
4.
Pull the mattress support backwards so that the gliding shoes can slide along the groove in the slide rails.
5.
Lift the mattress support at both ends.
Make sure that the castors are locked.

5.4 Mounting and removal of motors

Pull the mains cable out of the wall socket before removing the motor.
The cables must be fitted so that they cannot get caught in the cot's moveable parts.
If the height adjustable motor is to be removed, there must be a minimum of two persons to hold the mattress sup-
port and one to remove the motor.
UM_1542073_UK_DA_ver01.indd 21
21
2011-10-18 10:03:00

Publicité

Table des Matières
loading

Table des Matières