Ravelli MILD Manuel D'installation, D'utilisation Et D'entretien page 184

ENGLISH
After cleaning the combustion chamber, it is
advisable to proceed with the cleaning of the
inspection hatches as indicated in the paragraph
"Smoke duct cleaning".
18.3.2 Checking the gaskets
This operation must be carried out by a Ravelli
Service Centre. Plan this type of cleaning with
the Ravelli Service Centre.
When thoroughly cleaning the stove, the
authorised technician must check that the
gaskets of
• door
• inspection hatches
are intact. If not, they will have to be replaced.
184
18.3.3 Smoke duct cleaning
This operation must be carried out by a Ravelli
Assistance Centre. Schedule this type of cleaning
with the Ravelli Assistance Centre.
The stove is equipped with some hatches for
cleaning the internal smoke ducts.
To clean the smoke ducts, proceed as described
below:
STEP
Fig. 18.10
Note: The operation must be carried out when
the stove is cold, using an ash vacuum cleaner.
Fig. 18.11
Fig. 18.12
ACTION
1 Open the hatches
Clean the ashes, eventually use a
brush or similar and reassemble
everything.
2 Note: the hatches are equipped
with gaskets, therefore, before
reassembling them, make sure that
the gaskets are not worn.
Gasket
Fig. 18.13
Fig. 18.14
Hatch
Fig. 18.15