FPZ SCL K07R MD-MOR Instructions page 34

•
In some cases the lifting eye is turned 90° .
•
Before lifting the machine, proceed as follows:
•
Undo the screw
•
Put the lifting eye back in the correct position
•
Tighten the screw
12 INSTALLATION
12.1 INSTALLATION CONDITIONS
•
Make sure the conditions of use as described in section 3 are complied with, then proceed with installation of the machine as
specified below.
Danger due to limited visibility in the place where the unit is installed!
Make sure to always keep an eye on the installed unit when carrying out any operation in the installation area.
The control elements must be placed so that the installed unit can be seen.
34 / 113
ATTENTION!
Lifting the unit in any way
other than that indicated is
strictly prohibited. Use the
special lugs on the body of the
blower, motor or base