FPZ SCL K07R MD-MOR Instructions page 33

Failure to comply with the
conditions (par. 2.2):
- Ambient temperature outside the limits
or incorrect
- Altitude above 1000 m
- Failure to consider system and filter
pressure losses
Failure to install the filter (for use with
suction in the place)
Operation outside curve (P/Q)
(Pressure /Flow rate)
Rigid connection between the machine and
system
Use of the unit with current values not
corresponding to nominal
IMPROPER USE LINKED TO MAINTENANCE WORK
Failure to clean the filter
Failure to eliminate of layers of surface dust
FAULT CONDITIONS / EMERGENCY CONDITIONS
Not stopping the machine when making an
abnormal noise.
11 STORAGE AND TRANSPORT
Danger due to suspended loads.
The tipping over or falling of heavy loads can cause crushing and injury Place the packages in a stable way.
Do not place loads on the packages.
•
Store the machine in a dry place, if possible keeping it in its packaging.
•
Do not remove the protection from the openings.
Danger due to lifting of heavy loads!
The falling of heavy loads can cause crushing and injury or even death!
Before carrying out handling operations (lifting, moving, carrying, storage) check the weight, or mass (m), of the unit given in the
"SPECIFICATIONS" and decide the most suitable method in order to ensure maximum safety.
Therefore, all the risk prevention measures must be met, including any local and/or particular regulations on safe handling:
• by suitably qualified and adequately instructed personnel;
• using appropriate means;
• organising the work so that it is done with minimum risk and in safe and healthy conditions;
• with a safe and stable support surface;
• with the use of suitable work clothes and personal protection equipment (gloves and goggles, safety shoes and helmet);
• on a work area with sufficient space, flat floors, without obstacles;
• avoiding knocking, jerking and jolting.
Units weighting more than 25 kg have lugs for handling.
Different packaging is used, depending on the size and weight; once the package is brought near the installation area, open it, take out
the documents and then remove the machine as illustrated below.
operating Machine performance different from the data
given, possible motor faults and seizing of
the impeller
Particles entering the blower with seizing of
the impeller
Machine performance different from the data
given, possible motor faults and seizing of
the impeller
Abnormal vibrations for the machine and/or
system with possible seizing of the impeller.
Possible overheating of the machine and
motor when powered by an inverter.
Seizing of the impeller
Machine overheating
Damage with possible seizing of
impeller, machine overheating and possible
motor damage.
33 / 113
RISK FOR THE MACHINE
RISK FOR THE MACHINE
RISK FOR THE MACHINE, SYSTEMS
AND OPERATORS
RISK FOR THE MACHINE, SYSTEMS
AND OPERATORS
RISK FOR THE MACHINE
RISK FOR THE MACHINE
RISK FOR THE MACHINE, SYSTEMS
AND OPERATORS
the RISK FOR THE MACHINE, SYSTEMS
AND OPERATORS