Auto Power Off Function; Display Illumination - VOLTCRAFT VC950 Mode D'emploi

- Example of a possible measurement series with 11 values:
- At the apex T2, the next measurement point T3 decreases. The indicator is set to "Max" for T2 and to "Min" for T3.
- There is no change of the value at measurement point T4. No indicator is set here. At T5, the measurement value
increases to the next measurement value. The measurement point T5 is set to "Min". The value decreases again
after T6; indicator "Max" is set, etc.
- Press the button "CANCEL" to leave this function.
To delete all stored measured values, proceed as follows:
Switch off the meter.
Switch on the meter again with the "CANCEL" button pressed.
All stored measured values are now deleted.
h) Auto power off function
The DMM turns off automatically after 30 minutes if no button or rotary control is operated. This function protects the
battery, saves battery power and extends the operating time.
The switch-off time can be set between 1 and 60 minutes in the SETUP (see chapter 10), or the function can be
deactivated.
To reactivate the DMM after automatic shutdown, use the rotary control or press any key.
The Auto-Power-Off function is deactivated when the interface is activated so that the data connection is not inter-
rupted. This function remains inactive until the interface is switched off again.
i) Display illumination
The display is lighted automatically in bad lighting.
The illumination turns off automatically after 5 minutes if no button or rotary control is operated. This function protects
the battery, saves battery power and extends the operating time.
The switch-off time can be set between 1 and 60 minutes in the SETUP (see chapter 10), or the function can be
deactivated.
54