Product Description; Handling And Start-Up; Display Indications And Symbols - VOLTCRAFT VC950 Mode D'emploi

5. PRODUCT DESCRIPTION

The multimeter (referred to as DMM in the following) indicates measured values on a digital display. The DMM meas-
uring value display comprises 100,000 / 10,000 Counts (switchable).
The display can be switched too a smaller resolution. This increases the display speed.
If the DMM is not operated for a presettable time the unit turns off automatically. This saves the batteries and
enables a longer operating time. The automatic shutdown can be deactivated or is deactivated when the interface
is switched-on.
The meter can be used for do-it-yourself or for professional applications up to CAT IV.
For better readability, the DMM can also be optimally mounted with the standing bracket on the rear.
The battery and fuse compartments may only be opened when the test leads have been removed from the meter.
If test leads are incorrectly connected, an alarm sounds and the word "PrObE" appears on the display.
Connect the measuring lines correctly before measuring.

6. HANDLING AND START-UP

a) Display indications and symbols
The symbols and indications are different for each model. This is a list of all the possible symbols and indications.
Delta symbol for relative value measurement (=reference value measurement)
AUTO TEST means "automatic measuring range selection"
TrueRMS
True root mean square
HOLD
Data hold function
AUTO HOLD Automatic freezing of the measured value
Peak HOLD
Freezing of the peak value
dB Dezibel - logarithmic measuring unit
STORE
Store value
RECALL
Restore stored value
LOG RATE Recording rate
MAX
Maximum value
MIN Minimum value
AVG
Average
SETUP
Setup functions for other settings
DATA LOG Data logging
mem
Memory slot
DIGIT Display accuracy (decimal digits)
OL
Overload = the measuring range was exceeded
OFF
Switch position "off "
41