Sub-Menu And Additional Function; Store, Storing Measured Values; Recall, Reading Measured Values; Rel Function - VOLTCRAFT VC950 Mode D'emploi

9. SUB-MENU AND ADDITIONAL FUNCTION

a) STORE, storing measured values
The multimeter is able to manually save individual measured values.
To save the measured value, navigate to the item "STORE" in the
submenu and press "ENTER". The measured value is assigned a
programme memory slot. It is displayed in the upper display, alterna-
tively with the measured value saved.
To leave the memory function, press "CANCEL".
The max storage is 1,000 measured values.
b) RECALL, reading measured values
To view the measured values again, navigate to the item "RECALL"
in the submenu and press "ENTER". The last measured value stored
will be displayed.
To verify other measured values that were stored, switch through
the memory slots with the navigation buttons.
To leave the RECALL function, press "CANCEL".
c) REL function
The REL function allows a reference value measurement to avoid
possible line loss as it occurs, e.g., during impedance measure-
ments. For this purpose, the current indicated value is set to zero.
A new reference value is set. The basic value (rel difference) is dis-
played in the upper, small display.
Use the navigation buttons to move to the icon
menu.
Press the "ENTER" button to activate the function. The display indicates
" ". The automatic measuring range selection is deactivated
now.
You can now have the rel difference displayed either as value or
in %.
To switch off this function, press the button "CANCEL" or change the
measuring function.
The REL function is not active in the measuring rang-
es for temperature, continuity test, diode test, fre-
quency and low-pass filter voltage measurement.
in the sub-
51