Staubli GPV 14 Instructions De Montage Et D'utilisation page 6

Operating instructions
The nozzle is easy to operate
with only one hand, placed on
the handle of the device.
IMPORTANT !
Check the position of the filling
unit on the vehicle.
Present the nozzle in the axis of
the filling unit.
Refuelling
n
1/ Push the nozzle onto the
filling unit until it locks:
locking of the nozzle is
audible.
After refuelling is completed
n
1/ Switch the refuelling system
of the dispenser off and go
back to the nozzle.
Recommendations of use
1/ These nozzles are intended to deliver LPG for all types of vehicle according to the attached operating instructions.
Stäubli refuses to accept responsibility for any other use.
2/ These nozzles must to be used only with filling unit according to EN 13 760 standard.
6
IMPORTANT! Before connection, check that the lever moves
freely and is in low position.
2/ Pull on the lever until it locks
(overstroke).
Check the right locking of the
nozzle onto the filling unit by
pulling slightly.
(2)
2/ With one hand, hold the nozzle,
pull up the lever (1) then pull
out the nozzle from the filling
unit (2).
Lever in
high position
3/ Leave the nozzle and operate
the refuelling system of
the dispenser to start the
refuelling.
IMPORTANT!
In order to maintain the nozzle in
good working condition, it must
be stored out of the weather, sand
wind, mud, dust and in a storage
(1)
support.
It has to be kept in clean condition.
Lever in
low position
EN