Location And Connection; Set-Up And Operation - EUROM Safe-t-Heater 2000 Manuel D'utilisation

have physical, sensory and/or mental limitations, or by persons who have no knowledge of, or experience
with, this appliance.
21. Keep the heater clean. Dust, dirt and/or a build up of deposits in the heater are a common cause of
overheating. Make sure these deposits are removed regularly.
22. Do not turn on the appliance if you have discovered damage to the appliance, cord or plug, if the appliance is
malfunctioning, if it has been dropped or when there are signs of any other defect. Return the complete
product to the vendor or to a certified electrician for inspection and/or repair. Always ask for original parts.
23. Do not use attachments and/or accessories that have not been recommended or supplied by the
manufacturer.
24. The appliance (incl. cord and plug) may only be opened and/or repaired by properly authorised and qualified
persons.
25. Only use this heater for its intended purpose and as described in this instruction manual.
Not abiding by instructions 23, 24 and 25 may lead to damage, fire and/or personal injuries. A failure to adhere to
these rules also immediately nullifies the guarantee and vendor, importer and/or manufacturer do not take
responsibility for any of the consequences!
Description

Location and Connection


Remove all packaging material and keep out of reach of children. After removing packaging, check the
appliance for damage or other signs that could indicate a fault/defect/malfunction. In case of doubt, do not
use the appliance, but contact your vendor for inspection or replacement.

Choose a suitable location for the heater which is at least one metre away from any obstructions, walls or
inflammable materials (see also safety instructions).

Make sure a functioning heater is always placed on a solid, flat and horizontal surface.

Check if the mode selector dial is set to 'OFF' (O).

Fully extend the power cord and plug into a suitable 220-240V socket. To prevent the circuit overloading,
check that no other appliances are connected to the same group. (naar volgende regel!)

Set-up and Operation


Switch the heater on by turning the mode selector dial to one of three positions; The light at the front will turn
on.
Fan only (thermostat to maximum)
I
Heating at half power (1000W)
II
Heating at full power (2000W)
It is most economical to heat the space at full power, then to switch to half power to maintain the
temperature.

Both at half and full power, the fan rotates at the same speed; the difference between the two lies in the
number of heating elements in use.
A = Top
B = Front
C = Back
1 – control dial
2 – thermostat dial
3 – pilot light
4 – handle
5 – air outlet grill
6 – air intake grill
7 – oscillating function switch
8 – oscillating foot
12