Location And Connection - EUROM EK Delta 2000 Manuel D'utilisation

capacity of the device and will nullify the guarantee and the
manufacturer's liability.
5. If the electrical cable is damaged, it must be replaced by the
manufacturer, their service department or somebody with similar
qualifications in order to prevent creating a hazard.
Failing to adhere to points 3, 4, 5, could lead to damage, fire and/or
personal injury. They will invalidate the guarantee and the supplier,
importer and/or manufacturer shall not be liable for the consequences.
Description
EUROM EK heaters are 'real space' heaters, with a powerful fan which disseminates
a great deal of air.
Cold air is sucked in at the back, heated, and then blown out as hot air. Because a
relatively large quantity of air is sucked in and blown out, the air expelled by the
heater does not feel particularly hot. As a great deal of air is heated and blown out,
however, the entire space (not just the air around the heater!) is gradually warmed
up.
Control panel EK DELTA 2000
The control panel consists of two dials:
* The mode selector dial with 4 positions is located
on the left. From top to bottom:
 O or off
 650W power
 1300W power
 2000W power
* The continuously adjustable thermostat dial is located on the right.
Control panel EK DELTA 3000
The control panel consists of two dials:
* The mode selector dial with 4 positions is located
on the left. From top to bottom:
 O or off
 fan only
 1500W power (low)
 3000W power (high)
* The continuously adjustable thermostat dial is
located on the right.

Location and connection

 Remove all packaging material and keep out of reach of children. After removing
packaging, check the appliance for damage or other signs that could indicate a
27