Publicité
Les langues disponibles
Les langues disponibles
Before using your Handmixer for the
first time
Wash the parts (see 'Cleaning').
Key
Speed & Pulse selector
1
Tool SureEject™
2
Mixer
3
Beater
4
Beater with gear
5
Kneader
6
Kneader with gear
7
Mixing bowl
8
Cradle
9
Mixer release button
10
Cradle release lever
11
Stand
12
Splashguard
13
To Use your Handmixer
Fitting the Beaters/Kneaders
Refer to illustration
Insert the beater/kneader with the
plastic gear in the
Setting Up the Bowl & Stand
Refer to illustration
1
Fit the beaters/kneaders to the
Handmixer.
2
Hold the front of the cradle and
raise by pressing the cradle release
lever.
3
Place the bowl onto the stand.
4
Fit the mixer to the cradle and push
down to secure.
Note: Check that the beater/
kneader with the plastic gear aligns
with the drive gear on the cradle.
5
Add the ingredients, then lower the
cradle by holding the Handmixer
handle whilst pressing the cradle
release lever at the same time.
6
Plug in and select a speed (Refer to
the recommend usage chart).
A
socket.
A
F
–
Pulse
Slide the speed selector to the (P)
position to use in short bursts at
maximum speed. Note: the motor will
only operate for as long as the control
is held in position.
Splashguard
Fit the splashguard if required
After Use
Refer to illustration
1 Switch the speed selector to the 'O'
OFF position.
2 Hold by the handle and lift up the
cradle by pressing the cradle release
lever.
3 Remove the mixer from the cradle by
pressing the mixer release button and
lifting off.
4 Slide the tool SureEject™ down to
release the tools.
Note: The tools can only be removed
when the speed selector is in the 'O'
OFF position.
Note: When ejecting the tools hold the
hand mixer over the bowl.
Cord Storage
Wrap the cord round the heel of the
handmixer. Then store on the stand.
4
E
.
G
I
–
J
Publicité
