Grizzly ERM 1742 G Traduction De La Notice D'utilisation Originale page 72

GB
16 Release button (not visible)
17 Power inlet
18 Power cable
Assembly
Disconnect the plug before any
work on the equipment. There is a
risk of injury.
Assembling the Curved Handle
Tip up bottom bar:
1. Tip up the bottom bar (4) to your
favourite angular position.
2. Lock the bottom clamping
levers (6) by pushing them
towards the bar (4). Clamp-
ing levers to be tightened and
contacting the bar such that
they clamp at average force.
Otherwise you may have to
tighten (turn clockwise) or loos-
en them (turn anticlockwise).
Attach cable strain relief:
Push the cable strain relief
(14) over the curved handle
(1).
Install curved handle:
1. Use the screws and washers
from the package as well as the
top clamping levers (3) to mount
the curved handle (1) on the
right and left ends of the bottom
bar (4). Three positions are pos-
sible.
2. Turn the clamping levers (3)
clockwise.
3. Lock the clamping levers (3)
by pushing them towards the
bar (4). Clamping levers to be
tightened and contacting the
72
bar such that they clamp at
average force.
Otherwise you may have to
tighten (turn clockwise) or
loosen them (turn anticlock-
wise).
Clip on the cable hook:
Clip on the cable hooks (
13) to the bottom bar to fasten
the connection cable (
Installing the grass catcher
Assemble the grass catcher:

Clip the rubber lip of the grass
catcher net (19) into the hard plas-
tic tray of the grass catcher (9).
‚
Insert the linkage tubes (19) into
the grass catcher net (20). Make
sure to fully insert the tubes (see
ill. detail).
The tube bows fit into the
groove (21) at the bottom of the
grass catcher
ƒ
Pull the plastic straps (22) over
the linkage tubes (20).
„
Use the screws and washers
(23) from the package to mount
the linkage tubes (20).
Operation
Attention: Do not operate the ap-
pliance until the collision guard
and grass catcher are fully in-
stalled. Risk of injury!
Mounting / removing the grass
catcher
1. Lift the collision guard (5).
2. Place the grass catcher (7) on the
mounting bracket (24) provided at
,
, 15).