Télécharger Imprimer la page

Grizzly ERM 1742 G Traduction De La Notice D'utilisation Originale page 73

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 18
the back of the lawn mower.
3. Lower the collision guard (5)
onto the grass catcher (7) - it
will keep it in place.
4. To remove the grass catcher
(7), lift the collision guard (5)
and unhook the grass catcher
from the mounting bracket. Flap
down the collision guard to the
housing.
On emptying the grass catcher
also refer to section "Disposal/en-
vironment".
Adjusting the Cut Height
Switch off the equipment, discon-
nect the plug and wait for the blade
to stop. There is a risk of injury.
Hold the cutting height adjuster
(11) and move it to the correct cut-
ting height, as appropriate.
There are six different cutting heights:
35 - 45 - 55 - 65 - 75 - 85 mm
The correct height is around 30 – 45 mm
for a decorative lawn and around 30 – 65
mm for a used lawn.
A higher cut height should be
selected for the first cut of the sea-
son.
Switching On and Off
1. Plug the mains lead (18) into
the appliance's power inlet (17).
2. Turn the end of the mains lead
into a loop and hook it into the
cable strain relief (14).
3. Connect the equipment to the
power supply.
4. Before switching on, ensure that
the equipment is not in contact
with any objects.
5. To switch on, press the release
button (16) on the handle at the
same time as pressing the start
lever (2). Release the release
button (16).
6. To switch off, release the start
lever (2).
After switching off the equip-
ment, the blade continues to
turn for several seconds. Do not
touch the moving blade. There
is a risk of injury.
Level gauge
The level gauge is located on the side of
the grass catcher. The aerodynamic air
guidance provided by the flap also opti-
mises the filling.
Flap open:
grass catcher empty
Flap closed:
grass catcher full
Working with the Lawnmower
Regular mowing encourages increased fo-
liation of the grass and kills off weeds at the
same time. Therefore, not only does each
mowing increase the density of the lawn, it
also produces an evenly resilient lawn.
The first cut is to be made in around April,
at a growth height of 70 – 80 mm. In the
main vegetation period, the lawn is to be
mowed at least once a week.
GB
73

Publicité

loading