Publicité
Les langues disponibles
Les langues disponibles
Removing the oven door (Fig. 2a/Fig. 2b/Fig. 2c)
To facilitate oven cleaning, the oven door can be removed by operating on the hinges as follows:
– The hinges (A) are equipped with two movable saddles (B). Lift the saddle (B) to release the hinge.
– Then lift the door upwards and pull it outwards; to do this, hold the door at the sides near the hinges.
– To refit the door, firstly insert the hinges in the special grooves.
– Lastly, before closing the door, remember to turn the two movable saddles (B) previously used to hook the hinges.
Removing the oven door internal glass (Fig. 3)
The oven door can be removed to enable thorough cleaning of the internal glass, by proceeding as follows:
• with the door completely open, turn the two black blocks (with the word "CLEAN") at the bottom of the door 180° so
that they insert in the seats in the oven structure. NB: Make sure to turn them fully (in this position the blocks will click).
• Carefully lift the internal glass: the two blocks will prevent the door from closing (if the blocks are not turned fully,
removing the glass will cause immediate closing of the door).
After carrying out the cleaning operations, refit the internal glass (the correct position is indicated by the wording
"TEMPERED GLASS", which must be perfectly readable) and turn the two glass retaining blocks back to their original
position.
ATTENTION: Never try closing the door when only one or both blocks have partially or completely freed the internal
glass. After cleaning, always remember to turn both blocks before closing the door.
Replacing the oven lamp
Franke ovens are equipped with a circular lamp positioned in the top left at the back of the compartment.
To replace the oven lamp, proceed as follows:
– Switch off power to the appliance with the master power switch used in connecting
the oven to the mains supply, or by removing the plug from the mains socket, if it can
be reached.
Rear circular lamp:
– Unscrew the glass cover (A);
– Unscrew the lamp and replace it with one resistant to high temperature (300 °C),
having the following characteristics:
Voltage: 220/240V ~ 50-60Hz
Power: 15W
Fitting: (E14) small.
– Refit the glass cover (A) and reconnect the power supply.
Support
In case of any operation problems, contact a Franke Technical Service Centre
(see attached list).
Never resort to unauthorised technicians.
Specify:
– Type of fault;
– Appliance model (Art.);
– Serial number (S.N.).
This information is given on the appliance dataplate, on the warranty certificate.
Installation (Fig. 4)
Important: Installation must comply with the current standards and regulations. It must be only be carried out by
specialised and licensed personnel.
Cabinet requirements
For fitted units, the components (plastic materials and veneered wood) must be assembled with heat-resistant adhesives
(max. 100 °C): unsuitable materials and adhesives can result in warping and ungluing. The cabinet must allow sufficient
room for the electrical connections. The cabinet in which the oven in fitted must be strong enough to take the weight of
the equipment.
The oven must be securely installed in the recess. The oven can be installed in a column cabinet or under the top of a
modular unit, provided sufficient ventilation is guaranteed.
20
SM 51 G / CM 55 G
– 11 –
EN
A
Publicité
