Publicité
Les langues disponibles
Les langues disponibles
Fitting the door panel
Slide in the door panel all the way.
1.
Put the cover back in place and screw it in.
2.
Refit the appliance door.
3.
Cleaning the hook-in racks
You can remove the hook-in racks for easier cleaning.
m
Risk of burning due to hot components in the cooking
compartment!
Wait until the cooking compartment has cooled down.
Push the hook-in rack upwards at the front and unhook to the
1.
side.
Pull the hook-in rack forwards at the rear and unhook to the
2.
side.
1
Faults and repairs
In the event of a fault, check the tips in the following table
before calling the after-sales service.
Problem
Electrical operation is malfunctioning (e.g.
indicator lamps do not light up)
Liquid or thin dough runs to one side
Smoke is generated during roasting or
grilling
High levels of condensation are generated
in the cooking compartment
Enamelled accessories have light, matt
marks
Door panels are misted up
50
2
Possible cause
Faulty fuse
Appliance not installed level
Fat is burning on the grill element
Wire rack or universal pan inserted
incorrectly
Normal occurrence (e.g. when baking
cakes with very moist toppings or roasting
a large joint)
Normal occurrence caused by dripping
meat or fruit juices
Normal occurrence caused by
temperature differences
Clean the hook-in racks with washing-up liquid and a sponge
3.
or brush.
Align the hook-in rack with the indentation (a) facing
4.
upwards, so that the shelf heights match.
Insert the hook-in rack at the rear until the limit stop.
5.
Push the hook-in rack towards the rear.
6.
Insert the hook-in rack at the front until the limit stop.
7.
Push the hook-in rack downwards.
8.
m
Risk of electric shock!
Work on the appliance electronics may only be performed by
an expert. Disconnect the appliance from the power supply.
Switch off the circuit breaker or take out the fuse in the
household fuse box.
Remedial action
Check fuses in the fuse box and replace if
necessary
Check the appliance installation (see the
Installation instructions)
Continue grilling or roasting until the fat on
the grill element is burnt away
Place the wire rack in the universal pan
and insert them together at a lower shelf
height
Open the appliance door occasionally
during operation
Not possible
Heat the appliance up to 100 ºC and then
switch off again after 5 minutes
Publicité
