Arneg Chester 2 RTB Manuel D'instructions Et D'utilisation page 29

17_1.Shelf lighting (Rif. 17)
1 - Remove electric power supply to the cabinet.
2 - Remove the methacrylate protection 1
3 - Turn the bulb approx. 90° (until it clicks), extract it from the bulb-holder, replace it
with an identical new bulb;
4 - Reinsert the lamp, checking that the contacts are housed correctly in their specific
holes.
5 - Reassemble the protection in methacrylate.
6 - Restore electrical power supply.
18.Combining cabinets (Rif. 25)
To combine two or more cabinets in channel, proceed as follows:
1 - Remove the shoulders
2 - Position the cabinets side by side
3 - Remove the backrests to have access to the holes of the risers
4 - Join the risers and the brackets, using the screws supplied
5 - Reassemble the backrests.
Make sure that the knurled part of the plugs 4-5 is completely inserted into the
relevant seats.
CHANNEL COMBINATION KIT
Ref. Code
1 04711065
2 04480112
3 04230600
4 02047000
5 02940652
6 04711042
19.Anti-condensation and demisting
To prevent misting due to condensation, low power electrical heaters are foreseen on
the parts most subjected to this phenomenon, such as: heat insulating glass panels of
the doors, frames and framings, side glass panels, etc.
20.Maintenance and cleaning - qualified operator -
Before any operation, wait for the glass parts to have reached room
temperature.
Protect the hands with work gloves.
DO NOT use hot water on cold glass surfaces; the glass could crack and
injure the operator.
DO NOT use abrasive products and solvents that may alter the surfaces of the
cabinets
DO NOT spray water or detergent directly on the electrical parts of the cabinet.
DO NOT touch the cabinet with wet or damp hands and feet.
DO NOT use alcohol or similar products to clean the parts in methacyrlate
(Plexiglas).
DO NOT exert too much strength during the cleaning operations
DO NOT use chlorine-based detergent products such as bleach, that may
corrode the surfaces
05060086 00 20/02/2013
TCEI M8X120 screw (Hexagon Socket Head Cap Screw)
Washer D 8.5x24
Hex Nut M8
Profile alignment plug D 10
Alignment pin D 4x80
Screw TCEI M8x60
Description
Chester 2 RTB
English
29