hajdu HP-TOWER HPT200C Manuel De Mise En Service, D'opération Et D'entretien page 88

HPT 200 • HPT 200C
Installing a fi lter for the air input of the appliance. If the appliance is connected to an
air duct, a fi lter must be installed at the inlet of the air duct.
Condensate water discharge
Figure 9.1.-8. Figure 9.1.-9.
In order to ensure the continuous drainage of condensate water, please, install the ap-
pliance on a horizontal surface. If this is not feasible, please, ensure that the drainage
pipe branch is put in the lowest possible place. It is recommended to place the appli-
ance in such way that the angle of inclination between the appliance and the vertical
plane should not exceed 2°.
88