hajdu HP-TOWER HPT200C Manuel De Mise En Service, D'opération Et D'entretien page 60

HPT 200 • HPT 200C
2.4 Steps before installation, selection of installation location
Before starting any installation step, please, ensure that the planned location of the
water heater installation fulfi ls the following requirements:
a) It should be installed in a room of more than 8 m² fl oorspace. Do not place the ap-
pliance in a room exposed to the formation of ice. Do not place the appliance in
a room where another appliance works that requires air for its operation (i.e. gas
furnace, water heater operated by gas, etc.) It is forbidden to operate the hot wa-
ter tank outdoors or in a place exposed to rain or moisture.
b) In order to ensure adequate operation of the appliance and to facilitate its main-
tenance, the selected location has to allow suitable safety distances measured
from the walls and the ceiling (Figures 2.4.-1 and 2.4.-2.) Make sure that the fl oor
is fl at and stable enough.
c) Leg fi xing: Secure the 3 foot mounts supplied with the device with a minimum M8
screw with a push-in metal dowel (M8x75) drilled into the base. The position of
the footrest is as shown in Figures 2.4-3. Adjust the adjustable feet of the unit to a
minimum of 26 mm. (see Figures 2.4-4)
Carefully push the appliance in the direction of the leg fasteners already screwed
down, so that the adjustable legs hit the end of the open groove in the feet fas-
teners (Figure 2.4.-5.). If the appliance is operated without leg fastener, it may tip
over. In this case, the manufacturer assumes no liability for possible damages.
Carefully push the appliance in the direction of the leg fasteners already screwed
60
2.3. Overall dimensions and names
Connection to the
electrical network
Smar-grid PV
Condensate water
discharge
Ø25
Hot water outlet
G3/4
Heat exchanger
outlet G3/4
Heat exchanger
inlet G3/4
Cold water inlet
G3/4
Figure 2.3.-1