EN
FR
6. MAINTENANCE
6.2. Cleaning the Recovery Core
Maintenance of the recovery core is recommended every two years according to the following procedure:
1.
Switch off power supply.
4.
Tilt the door forward and lift.
6.
Remove the exchanger by pulling slowly.
Replace the heat exchanger cap, then the front door and finally the filter cap (steps 1 to 5).
26
2.
Open the filter cover.
4'.
7.
Clean heat exchanger with a vacuum cleaner
(no water or solvents).
3.
Remove the 2 screws securing the door.
5.
Remove heat exchanger cap.
8.
Replace the exchanger by carefully pushing it
carefully horizontally.