Publicité
Les langues disponibles
Les langues disponibles
5-1. Serial Number And Rating Label Location
The serial number and rating information is located on the back of the unit. Use rating label to determine input power requirements and/or rated
output. For future reference, write serial number in space provided on back cover of this manual.
5-2. Selecting A Location
SECTION 5 − INSTALLATION
1
18 in.
(460 mm)
2
!
Only qualified persons should
install, operate, maintain, and
repair this unit.
!
Installation must meet all Na-
tional, State, and Local Codes
− have only qualified persons
make this installation.
!
Do not move or operate unit
where it could tip.
!
Do not use this equipment to
support
tools, or other material.
!
Special installation may be re-
quired where gasoline or vola-
tile liquids are present − see
NEC Article 511 or CEC Sec-
tion 20.
1
Lifting Forks
2
Locking Casters
3
115 Volt, 15 Amp AC Grounded
Receptacle
4
Input Power Cord
Use casters or lifting forks to move
unit.
If using lifting forks, extend forks be-
yond opposite side of unit.
Position unit near the welding opera-
tion and close to 115 volt AC recep-
tacle but away from obstructions that
may restrict movement of the fume
3
collector or collection hose.
.
A 115 volt AC, 15 amp individual
branch circuit protected by time
delay (type D) fuses or circuit
breaker is required.
4
personnel,
large
LocFiltair130 2016-02 − 245 353
OM-244785 Page 13
Publicité
