Vortice AIRLINK 30 Livret D'instructions page 45

ENGLISH
IR remote control (HCS models only)
HCS models are equipped with a remote control with LCD display. By default the recovery function, the auto-
comfort, auto HR% and autonight modes are active. The humidity threshold is set at the maximum value (90%)
and the speed is set to the maximum in order to obtain the maximum air flow rate (5 fans displayed).
The remote control transmits its default state to the device and consequently updates the state on the appliance.
If the state of the device does not synchronize with the state of the remote control, point the remote control towards
the device and press a button on the remote control to activate the synchronization. After inserting the batteries,
the remote control is active. After pressing the ON / OFF button, the dispay looks like in figure 30:
30 30
Keys description:
• ON/OFF FUNTION
Press ON/OFF key to start the device or to select the STANDBY mode.
• FAN SPEED FUNCTION
Fan speed selection is always available. Press Fan key
\LOW\MED\HIGH\BOOST). Fan speed mode will cycle as below:
FAN SPEED
>MINIMUM > LOW > MED > HIGH
> BOOST > MINIMUM...
•
"AUTO NIGHT" FUNCTION
AUTO NIGHT function is always available. Press NIGHT AUTO button
function on and off.
AUTO NIGHT
>ON > OFF > ON >...
FUNCTION
HEAT RECOVERY MODE
AUTO COMFORT FUNCTION
TIMED BOOST FUNCTION
SUPPLY MODE
EXTRACTION MODE
NATURAL VENTILATION
AUTO HR % (60% - 75% - 90%)
AUTO NIGHT
FAN SPEED
LOW BATTERY
LCD ICON
> > >
LCD ICON
> > >
Default state LCD ICON
ON
ON
OFF
OFF
OFF
OFF
HIGH (90% - three drops
on)
ON
HIGH (five fans displayed)
OFF
to select fan speed (MINIMUM
> >
at any time to toggle NIGHT AUTO
...
> ...
45