Vortice AIRLINK 30 Livret D'instructions page 42

ENGLISH
Note: only one unit must be set as MASTER in a specific network . The other units must be set as
!
SLAVE
To set the device as "Wi-Fi Mesh" Slave:
• Press simultaneously the SPEED - MODE - FUNCTION buttons.
• Press in sequence the following buttons: MODE - MODE - SPEED - SPEED - FUNCTION - FUNCTION.
• Press the SPEED button within 20 sec.
• All speed LEDs from 1 to 5 will blink briefly to indicate that the device has been set as Slave.
• If the SPEED button is not pressed within 20 sec, the device will return to normal operation without making any
changes to the settings.
To set the device as "Even Unit":
• Press simultaneously the buttons: SPEED - MODE - FUNCTION
• Press in sequence the buttons: SPEED - SPEED - FUNCTION - FUNCTION - MODE - MODE.
• Press the SPEED button within 20 sec.
• All speed LEDs from 1 to 5 will blink briefly to indicate that the device has been set as an even numbered unit.
• If the SPEED button is not pressed within 20 sec, the device will return to normal operation without making any
changes to the settings.
To set the device as an "Odd Unit":
• Press simultaneously the SPEED - MODE - FUNCTION buttons.
• Press in sequence the buttons SPEED - SPEED - FUNCTION - FUNCTION - MODE - MODE.
• Press the FUNCTION key within 20 sec.
• All speed LEDs from 1 to 5 will blink briefly to indicate that the device has been set as an odd-numbered unit.
• If the Function button is not pressed within 20 sec, the device will return to normal operation without making
any changes to the settings.
Wi-Fi Mesh Network
The Wi-Fi module creates a mesh wifi network to synchronize the units. The mesh network is identified by a
particular SSID (Service Set Identifier), which will be generic by default during installation and will become unique
for each particular network once installation is completed.
To set the SSID (Service Set Identifier) of the Wi-Fi mesh network
The machines are set as SLAVE by factory default. You must therefore set a unit as MASTER by
!
pressing the MODE - MODE - SPEED- SPEED - FUNCTION – FUNCTION buttons in sequence and
then the MODE button.
• Press the SPEED - MODE - FUNCTION buttons on the MASTER unit at the same time.
• Press the MODE - MODE - SPEED - SPEED - MODE - MODE buttons in sequence.
• Press the SPEED button within 20 seconds
• All speed LEDs from 1 through 5 will briefly blink to indicate that SSID = VOR_XXXXXXXX has been set on
EACH SINGLE UNIT IN THE NETWORK
• If the SPEED button is not pressed within 20 seconds, all SPEED LEDs from 1 to 5 will light up for 1 second
without blinking to indicate that the appliance will return to normal operation without resetting the network
SSID.
Note: The change from the default network SSID "VORTICE_HRW" to a unique network SSID is
!
mandatory in order to prevent interference between different devices belonging to different
networks (for example, in the case of two independent flats separated by a wall, etc.).
Note: you must have a smartphone or network detection device handy to view the names of the
!
assigned networks.
42