Vortice AIRLINK 30 Livret D'instructions page 28

ENGLISH
Description and use
VORT MONO AIRLINK (hereinafter 'the device') is a decentralised heat recovery ventilation system with an
integrated WI-FI module for synchronisation with several units. The device can be wall-mounted in perimeter walls
between 260 mm (283 mm for VORT MONO AIRLINK 40) and 700 mm thick.
The device is available in four versions:
- Installation inside holes with a nominal diameter of 100 mm and a maximum air flow rate (in boost mode) of
38 m 3 /h:
• VORT MONO AIRLINK 30 with on-board machine controls.
• VORT MONO AIRLINK 30 HCS with remote control and relative humidity, temperature and ambient
light sensors.
- Installation inside holes with a nominal diameter of 160 mm and a maximum air flow rate (in boost mode) of
3
40 m /h:
• VORT MONO AIRLINK 40 with on-board machine controls.
• VORT MONO AIRLINK 40 HCS with remote control and relative humidity, temperature and ambient
light sensors.
Humidity, temperature and ambient light sensors. integrated in HCS versions, allow the automatic operation of
the device ("Auto HR%", "Auto Comfort", "Auto night" functions).
- Maximum absorbed power VORT MONO AIRLINK 30: 5W.
- Maximum absorbed power VORT MONO AIRLINK 40: 6W.
Common features for all models:
- WI-Fi module for Mesh network.
- Buttons with LED indicators.
- 5 speeds corresponding to 5 airflows.
- 1 input suitable for remote connection with cable compatible with external modules "VORTICE C TEMP"
(temperature sensor) and "VORTICE C HCS" (humidity sensor) or equivalent. Cable length≤30m.
- 1 direct output for fan control.
- Long-term timer (3/6/12 months) with daily increase for filter clogging control.
- Insulation class: II.
- Power supply: 220-240V ~ 50-60Hz.
Compliance
• This appliance can be used by children no less than 8 years of age
and by individuals with limited physical, sensory or mental capacities,
or by inexperienced or untrained individuals, provided that they are
supervised or have been instructed in safe use of the appliance and
understand the associated risks. Children must not play with the
appliance. Cleaning and maintenance procedures that can be
undertaken by the user must not be entrusted to children, unless
under supervision.
• These appliances are designed for use in residential and commercial
properties.
• The appliance must be installed by a professionally qualified
electrician.
• The electrical system to which the product is connected must be in
compliance with applicable regulations.
• An omnipolar switch with a contact opening distance of 3 mm or
higher should be provided for installation, enabling complete
disconnection under overvoltage category III conditions.
• Products equipped with single-phase wiring (M) engines ALWA YS
require connection to 220-240V (or only 230V where required) single-
28