Abicor Binzel ABIDRIVE V2 Mode D'emploi page 61

TIG cold-wire feeder
12 Disposal
When disposing of the system, local regulations, laws, provisions, standards and guidelines must be observed. To correctly
dispose of the product, it must first be disassembled.
Please take note of the following information:
 11 Disassembly on page EN-28
12.1 Materials
This product is mainly made of metallic materials, which can be melted in steel and iron works and are thus almost infinitely
recyclable.
The plastic materials used are labelled in preparation for their sorting and separation for later recycling.
12.2 Consumables
The TIG cold-wire feeder itself does not contain any consumables.
12.3 Packaging
ABICOR BINZEL has reduced the transport packaging to the necessary minimum. The ability to recycle packaging
materials is always considered during their selection.
BAL.0415.0 • 2018-10-22
12 Disposal
EN - 29